Arduino Adafruit Motor Shield Kullanımı. However if you have code for the older shield adapting the code to use the new shield isnt difficult. Connect an fs5106b motor to servo motor port 1 labeled servo 1 on the shield.
We kept the ability to drive up to 4 dc motors or 2 stepper motors but added. Connect a six wire portescap stepper motor to motor port 2 labeled m3 and m4 on the shield. I have not soldered the shield onto the arduino which is an uno yet because i dont want to make anything permanent yet.
To use the shield on an arduino youll need to install the adafruit motorshield v2 library.
Due to high demand expect some shipping delays at this time orders may not ship for 1 2 business days. The tb6612 mosfet drivers have been used in place of the previously used l293d d. Connect an fs5106b motor to servo motor port 1 labeled servo 1 on the shield. It does not matter which wire goes into which terminal block as motors are bi directions.